Bryant T2SNAC01 Bedienerhandbuch PDF herunterladen

T2SNAC01, T2SNHP01

NON--PROGRAMMABLE THERMOSTAT

Installation Instructions

A08148

NOTE: Read the entire instruction manual before starting the

installation.

SAFETY CONSIDERATIONS

Read and follow manufacturer instructions carefully . Follow all

local electrical codes during installation. All wiring must conform

to local and national electrical codes. Improper wiring or

installation may damage thermostat.

Recognize safety information. This is the safety-- alert symbol

When you see this symbol on the equipment and in the instruction

manual, be alert to the potential for personal injury.

Understand the signal words DANGER, WARNING, and

CAUTION. These words are used with the safety--alert symbol.

DANGER identifies the most serious hazards which will result in

severe personal injury or death. WARNING signifies a hazard

which could result in personal injury or death. CAUTION is used

to identify unsafe practices which may result in minor personal

injury or product and property damage. NOTE is used to highlight

suggestions which will result in enhanced installation, reliability, or

operation.

Power

Note that all thermostats are dual powered where batteries can be

installed or in the presence of R and C (24vac) are not required.

Two AA batteries are furnished with the product.

Models

There are 2 different models. The 5th and 6th letters of the p art

number indicate the model. These 2 letters also appear on the

package and on the circuit board. Be sure to have the proper

thermostat for the intended application. Models are:

AC -- 1 --stage cool, 1-- stage heat for AC systems only.

HP -- 1--stage cool, 2--stage heat for either HP, or AC with 2--stage

heat.

Use each only for its intended purpose. See Table 1.

INSTALLATION

Thermostat Location

Thermostat should be mounted:

S Approximately 5 ft. (1.5m) from floor.

S Close to or in a frequently used room, preferably on an inside

partitioning wall.

S On a section of wall without pipes or duct work.

Thermostat should NOT be mounted:

S Close to a window, on an outside wall, or next to a door leading

to the outside.

S Exposed to direct light and heat from a lamp, sun, fireplace, or

other temperature--radiating object which may cause a false

reading.

S Close to or in direct airflow from supply registers and return--air

grilles.

S In areas with poor air circulation, such as behind a door or in an

alcove.

Select Model

AC Model

(1-- stage cool, 1 --stage heat) is to be used for single stage heating

and/or cooling applications only.

HP Model

(1--stage cool, 2--stage heat) can be used with a single--speed heat

pump (HP), or an air conditioner (AC) with a 2 --stage furnace or

fan coil. Software Option 5 selects HP/AC operation. This

thermostat comes configured from the factory as a heat pump

thermostat. Select AC in software Option 5 for AC operation.

1 2 3 4 5 6 7 8 9 10

Inhaltsverzeichnis

Seite 1 - Installation Instructions

T2SNAC01, T2SNHP01NON--PROGRAMMABLE THERMOSTATInstallation InstructionsA08148NOTE: Read the entire instruction manual before starting theinstallation.

Seite 2 - Set Thermostat Con figuration

2NOTE: If 2 dashes (---- ) appear, your thermostat does not includethe outdoor temperature function or the function is not workingproperly. Check with

Seite 3 - While in configuration mode:

2Table 1 – Model Selection and Wiring Diagram ChartOUTDOOR UNITAIR CONDITIONER1 SpeedHEAT PUMP1 Speed1--- Stage Furnace Model AC See Fig. ---2--- Stag

Seite 4

3To enter the configuration mode:To enter Configuration Mode, hold the FAN button down forapproximately 15 seconds. After the 15 second period, Option

Seite 5

43. Press MODE button once. The SET icon will come on. Thedisplay now shows Option 07 setting.4. Use up and down buttons to move between availableOpti

Seite 6 - WIRING DIAGRAM NOTES:

5To Select:1. Enter configuration mode (if not already there).2. Use up and down buttons to display Option 21. The SETicon should be off.3. Press MODE

Seite 7 - OPERATIONAL INFORMATION

6Thermostat Fan Coil Heat PumpO/B OHeatWW WCoolYY YFanGG24VACRR RCommonCC C*A08163*Common connection not required if batteries are used.Fig. 4 -- HP T

Seite 8 - C --- 0 1

7OPERATIONAL INFORMATIONFive--minute Compressor T imeguardThe cycle timer limits the number of times the heating or cooling equipment can be energized

Seite 9 - Homeowner’s Guide

8Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.E20

Seite 10 - COMMON TERMS

T2SNAC01, T2SNHP01NON--PROGRAMMABLE THERMOSTATHomeowner’s GuideA08147CONGRATULATIONSINTELLIGENT, EASY TO USECongratulations on your purchase of a new

Kommentare zu diesen Handbüchern

Keine Kommentare

Bryant T2SNAC01 Bedienerhandbuch

Stöbern Sie online oder laden Sie Bedienerhandbuch nach Thermostate Bryant T2SNAC01 herunter. Bryant T2SNAC01 Instruction manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Thermostate Bryant T2SNAC01