Bryant 4-Way Multipoise Fixed-Capacity Direct-Vent Conden Bedienungsanleitung Seite 1

WARNING: ELECTRICAL SHOCK, FIRE,OR EXPLOSION HAZARDFailure to follow safety warnings exactly could result indangerous operation, serious injury, death

1. LED flashes a current status code, or code 11, 4 times.Record this status code for further troubleshooting.2. The inducer will start and continue t

A99118Fig. 14—Inducer Housing Drain TubeA99119Fig. 15—Funnel in Drain and Antifreeze RunningThrough Trap—11—

Fig. 16—Wiring Diagram A02157PCBTRANFRSNOTE #11LSPRS(WHEN USED)LGPSFUSED OR CIRCUIT BREAKERDISCONNECT SWITCH (WHEN REQ’D)NOTE #2JBL1L1BLWRHI/LOTO 115

Fig. 17—Service LabelA02154SERVICETo initiate the component test sequence, shut OFF the room thermostat or disconnectthe "R" thermostat lead

A02204aIs LED status light on?Is LED status light blinking rapidly without apause?Is LED status light blinking ON/OFF slowlywith a combination of shor

A02204b11 NO PREVIOUS CODE – Stored codesare erased after 72 hours. On RED LEDboards stored status codes can also beerased whenever power (115V or 24

© 2002 Bryant Heating & Cooling Systems 7310 W. Morris St. Indianapolis, IN 46231—16—Printed in U.S.A. sp0558 Catalog No. 5335-207

CSA B149.1-00 (NSCNGPIC) in Canada; and the InstallationStandards, Warm Air Heating and Air Conditioning Systems(NFPA 90B) ANSI/NFPA 90B. In Canada, r

WARNING: Turn off the gas and electrical supplies tothe unit before performing any maintenance or service.Follow the operating instructions on the lab

1. Turn off electrical supply to furnace.2. Remove main furnace door and blower access panel.3. Disconnect blower motor wires from furnace control.Fie

7. Remove screws that secure manifold to burner box. (SeeFig. 5.)NOTE: Do not remove burner box from cell panel.8. Remove manifold, orifices, and gas

CAUTION: The ground wire from the gas valve MUSTbe attached to the burner box attachment screw. Failure toattach this ground wire to an adequate casin

14. Check furnace operation through 2 complete heat operatingcycles. Check area below inducer housing, vent pipe, andcondensate trap to ensure no cond

box or inlet pipe, but can be removed without removingeither. After removing screw, slide igniter and brackettoward outside of burner box and pull str

1. Turn off electrical supply to furnace.2. Remove main furnace door.3. Disconnect cap from unused drain tap on inducer housing.(See Fig. 14.)4. Conne