Bryant TSTATBBN2S01-C Installationshandbuch PDF herunterladen (Seite 3)

Page 3

To avoid equipment damage, DO NOT use

these units as a source of heating or cooling

during the construction process. The mechanical

components and ﬁ lters used in these units will

quickly become clogged with construction dirt

and debris which may cause system damage.

To avoid the release of refrigerant into the

atmosphere, the refrigerant circuit of this unit

must be serviced only by technicians who meet

local, state and federal proﬁ ciency requirements.

All refrigerant discharged from this unit

must be recovered WITHOUT EXCEPTION.

Technicians must follow industry accepted

guidelines and all local, state and federal statutes

for the recovery and disposal of refrigerants.

If a compressor is removed from this unit,

system refrigerant circuit oil will remain in the

compressor. To avoid leakage of compressor oil,

the refrigerant lines of the compressor must be

sealed after it is removed.

Pre-Installation

Installation, operation and maintenance instructions

are provided with each unit. Before unit start-up, read

all manuals and become familiar with the unit and its

operation. Thoroughly check the system before operation.

Prepare units for installation as follows:

1. Compare the electrical data on the unit nameplate

with ordering and shipping information to verify the

correct unit has been shipped.

2. Keep the cabinet covered with the shipping carton

until installation is complete and all plastering,

painting, etc., is ﬁ nished.

3. Verify refrigerant tubing is free of kinks or dents and

that it does not touch other unit components.

4. Inspect all electrical connections. Connections must

be clean and tight at the terminals.

Remove Fan Motor shipping bracket in rear of

Air Handler compartment.

Table 1. Physical Data

MODEL 036 042 048 060 072

Fan Wheel (Dia. X Width), in. 9 X 7

Fan Motor & HP ECM - 1/2 ECM - 1/2 ECM - 1

No. Refrigerant Circuits 2 2 2 2 2

Compressors 2 - Rotary

No. Coaxial Heat Exchangers 2 2 2 2 2

R - 22 Charge (Sys A / Sys B), oz 40 / 40 57 / 59 62 / 62 54 / 54 58 / 58

Water Connection Size (fpt swivel) 1" 1" 1" 1" 1"

Air Coil Length x Height, in.

20 X 24 24 X 24 24 X 32 24 X 36 24 X 36

Filter - 1" ElectroStatic (Std.) 24 x 24 27 x 31 27 x 31 27 x 35 27 x 35

Weight - Operating (lbs.) 225 275 305 385 450

Weight - Packaged (lbs.) 235 285 315 395 460

Rev.: 8/07/04D

All units have txv expansion devices, 20 ga sheet metal,

and 7/8" & 1-1/8" electrical knockouts.

All units have dual 1" Swivel water connections (4 total)

HWG utilizes 1/2" fpt water connections and is available only on circuit A.

All units have 3/4" fpt condensate drain connections.

2 - Scroll

11 X 10 11 X 10

ECM - 1

2 - Scroll

1 2 3 4 5 6 7 8 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Bryant TSTATBBN2S01-C Installationshandbuch Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Thermostate Bryant TSTATBBN2S01-C